Choose a malocclusion and an age group. The steps show how treatment typically proceeds in our practice and which appliances are used.
Schematic illustration, typical course, varies individually.
Malocclusion
Age group
Jaw joint problems
In the early mixed dentition, the upper jaw is widened and a class III plate is used. Whether further steps are needed later depends on growth.
Covered by statutory health insurance only for certain findings.
Schematic illustration, typical course, varies individually.
Step 1 of 7: Initial situation
Step 1
The lower front teeth sit in front of the upper ones.
Step 2
If there are jaw joint problems, their cause is clarified before orthodontic treatment. Depending on the findings, splint therapy comes first, supplemented by physiotherapy and self-care.
Occlusal splint
A removable acrylic splint, usually worn at night. It is intended to relieve the jaw joints and chewing muscles.
Step 3
A palatal expander widens the upper jaw. Depending on the findings, it is used as a fixed appliance or as a removable plate.
Rapid palatal expander (fixed)
A fixed appliance on the palate with an expansion screw. It is attached to back teeth and widens the upper jaw across the palatal suture.
Step 4
The class III plate is intended to support the forward development of the upper jaw. The aim is for the upper front teeth to sit in front of the lower ones again.
Class III plate
A removable plate intended to support the forward development of the upper jaw and to influence the position of the front teeth.
Step 5
The lower jaw can continue to grow forward until growth ends. Development is therefore checked regularly.
Step 6
In the permanent dentition, fixed braces align the teeth depending on the findings.
Fixed braces (multibracket)
Brackets on the teeth and an archwire move the teeth step by step into the planned position.
Step 7
After active treatment, retainers hold the tooth position that has been achieved. The retention phase is an integral part of treatment.
Fixed retainer
A thin wire on the inside of the lower front teeth. It holds the tooth position that has been achieved.
Clear retainer trays
Thin, clear plastic trays for the upper and lower jaw. They fit closely over the teeth and hold the tooth position that has been achieved. In the lower jaw, the tray fits over the fixed retainer.