Understanding malocclusions

Choose a malocclusion and an age group. The steps show how treatment typically proceeds in our practice and which appliances are used.

Schematic illustration, typical course, varies individually.

Early treatment for overjet

With clearly protruding front teeth, early treatment can lower the risk of front-tooth injuries. The actual correction usually follows in the later mixed dentition.

Covered by statutory health insurance only for certain findings.

Schematic illustration, typical course, varies individually.

Step 1 of 5: Initial situation

  1. Step 1

    Initial situation

    The upper front teeth protrude clearly, and the lower jaw sits back.

  2. Step 2

    Double advancement plate (Doppelvorschubplatte)

    The double advancement plate holds the lower jaw in a forward position when biting together. The overjet of the front teeth is reduced.

    • Double advancement plate (Doppelvorschubplatte)

      Removable upper and lower plates with inclined guiding surfaces. When biting together, the lower jaw is held in a forward position.

  3. Step 3

    Monitoring the change of teeth

    While the teeth are being replaced, development is checked regularly.

  4. Step 4

    Fixed braces with Mini Activator

    In the permanent dentition, fixed braces align the teeth. Depending on the findings, a Mini-Aktivator holds the lower jaw in a forward position at the same time.

    • Fixed braces (multibracket)

      Brackets on the teeth and an archwire move the teeth step by step into the planned position.

    • Mini Activator

      A small acrylic block behind the upper front teeth, attached to the fixed braces. It holds the lower jaw in a forward position at all times. Depending on the findings, the back teeth have no contact at first and then come together again; raising the bite is usually not intended.

  5. Step 5

    Stabilisation (retention)

    After active treatment, retainers hold the tooth position that has been achieved. The retention phase is an integral part of treatment.

    • Fixed retainer

      A thin wire on the inside of the lower front teeth. It holds the tooth position that has been achieved.

    • Clear retainer trays

      Thin, clear plastic trays for the upper and lower jaw. They fit closely over the teeth and hold the tooth position that has been achieved. In the lower jaw, the tray fits over the fixed retainer.

Depending on the findings, other approaches may also be considered. They are discussed in the consultation.

Questions about cost coverage are answered on the page Costs and KIG classification.

Arrange a consultation appointment

Sources of the 3D illustration

  • Anatomical basis: BodyParts3D, © The Database Center for Life Science (DBCLS), licensed under CC BY 4.0, simplified and modified for this illustration. Source and licence