Understanding malocclusions

Choose a malocclusion and an age group. The steps show how treatment typically proceeds in our practice and which appliances are used.

Schematic illustration, typical course, varies individually.

Overjet during growth

Around the growth spurt, the position of the lower jaw is influenced with removable or fixed appliances. Most of the correction comes from tooth movement.

Covered by statutory health insurance only for certain findings.

Schematic illustration, typical course, varies individually.

Step 1 of 5: Initial situation

  1. Step 1

    Initial situation

    The upper front teeth protrude, and the lower jaw sits back.

  2. Step 2

    Clarification and, if needed, splint therapy before orthodontic treatment

    If there are jaw joint problems, their cause is clarified before orthodontic treatment. Depending on the findings, splint therapy comes first, supplemented by physiotherapy and self-care.

    • Occlusal splint

      A removable acrylic splint, usually worn at night. It is intended to relieve the jaw joints and chewing muscles.

  3. Step 3

    Double advancement plate (Doppelvorschubplatte)

    The double advancement plate holds the lower jaw in a forward position while growth is still expected.

    • Double advancement plate (Doppelvorschubplatte)

      Removable upper and lower plates with inclined guiding surfaces. When biting together, the lower jaw is held in a forward position.

  4. Step 4

    Fixed braces with Mini Activator

    Fixed braces align the teeth. The Mini-Aktivator behind the upper front teeth holds the lower jaw in a forward position at all times. Depending on the findings, the back teeth have no contact at first and then come together again.

    • Fixed braces (multibracket)

      Brackets on the teeth and an archwire move the teeth step by step into the planned position.

    • Mini Activator

      A small acrylic block behind the upper front teeth, attached to the fixed braces. It holds the lower jaw in a forward position at all times. Depending on the findings, the back teeth have no contact at first and then come together again; raising the bite is usually not intended.

  5. Step 5

    Stabilisation (retention)

    After active treatment, retainers hold the tooth position that has been achieved. The retention phase is an integral part of treatment.

    • Fixed retainer

      A thin wire on the inside of the lower front teeth. It holds the tooth position that has been achieved.

    • Clear retainer trays

      Thin, clear plastic trays for the upper and lower jaw. They fit closely over the teeth and hold the tooth position that has been achieved. In the lower jaw, the tray fits over the fixed retainer.

Depending on the findings, other approaches may also be considered. They are discussed in the consultation.

Questions about cost coverage are answered on the page Costs and KIG classification.

Arrange a consultation appointment

Sources of the 3D illustration

  • Anatomical basis: BodyParts3D, © The Database Center for Life Science (DBCLS), licensed under CC BY 4.0, simplified and modified for this illustration. Source and licence